Tag Archives: mount

First Look at the Raspberry Pi Camera with CS Mount Lens

Raspberry PI Camera
PDF24    Send article as PDF   
Back at the end of December 2013 I discovered and purchased a Raspberry Pi Camera Board with a CS Mount Lens already fitted and is supported in the latest version of Raspbian, Raspberry Pi’s preferred operating system. The ArduCAM Group have released an add-on camera module for Raspberry Pi which is fully compatible with official one. The camera duly turned up a fortnight later in a small box which had been packed with great care. I finally organised myself to check the Raspberry Pi Camera module a few days ago.

Raspberry Pi Camera Board with CS Mount Lens

RasPi CSI Camera
en.pdf24.org    Send article as PDF   

Fully Compatible with Official Camera Module.

In order to meet the increasing need of Raspberry Pi compatible camera modules. The ArduCAM Group have released a add-on camera module for Raspberry Pi which is fully compatible with official one. It attaches to Raspberry Pi by way of one of the two small sockets on the board upper surface. This interface uses the dedicated CSI interface, which was designed especially for interfacing to cameras. The CSI bus is capable of extremely high data rates, and it exclusively carries pixel data. The camera is supported in the latest version of Raspbian, Raspberry Pi’s preferred operating system.

Technics Mount for RC type Servo Motors

PDF24    Send article as PDF   
I have tried a number of methods of mounting Radio Control type Servo Motors to Lego Technics models over the years. Non were overly successful, mostly due to alignment issues. Then in the wee hours this morning, whilst trying to sleep, the answer hits me. Out of bed I jumped (tip-toed), because finally there was a solution, thanks to Lego’s new new Part #64179: Gray Technic, Lift-arm with 5 x 7 Open Centre. 55gram RC Servo Motors fit tightly inside these new frames, accepting the Servo output shaft doesn’t align with the mounting holes in the 5 x 7Liftarm Frame. But this is a relatively easy fix that takes about 10 minutes, plus a day for the glue to reach full strength.



Do NOT follow this link or you will be banned from the site!
error: Content is protected !!