Tag Archives: getting

Getting Started with the LEGO Mindstorms & the PixyCAM

PDF24    Send article as PDF   

I trust this article will get you up an running quickly with PixyCAM and the LEGO Mindstorms EV3 (NXT). Please make sure you have a LEGO Mindstorms EV3 or NXT brick with a fresh set of batteries. I will endeavor to be as detailed as possible throughout this guide, but it helps if you are somewhat familiar on how to use your LEGO Mindstorms Robotics System.

Getting Started with the BeagleBone ‘Black’

en.pdf24.org    Send article as PDF   

This Article was written by Rui Santos and Luís Perestrelo authors of BeagleBone For Dummies.

Introduction

BeagleBone BlackThe BeagleBone Black is a low-cost embedded Linux computer that has found love in the workbenches of many hobbyists, engineers and developers. Operating at 1GHz, providing the possibility to have lots of memory (thanks to its microSD card slot) and access to the Internet, this tiny board is a quite powerful computer on its own. (It also looks great. Something about those rounded edges, probably) Its niche, however, is probably the fact that it features an absurd amount of input and output pins, along with several interfaces that allow different devices to be connected and different communication protocols to be used (you can see a list of those by the end of this post). This bridges the gap between the realms of computing and electronics, allowing to create complex and ambitious electronic projects — often interacting with the Web — while experiencing little to none software or hardware constraints.

NXT2WiFi, Webserver Sensor – Getting Started Guide

PDF24    Send article as PDF   
My NXT2WiFi, Webserver module for LEGO® MINDSTORMS® NXT robots arrived a couple of weeks ago from Daniele Benedettelli. I finally got around to unpacking this new sensor today. In fact the weather here today made the decision very easy.



Do NOT follow this link or you will be banned from the site!
error: Content is protected !!